|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-16-2002, 02:44 PM
|
#1 |
|
Registered User
Join Date: Nov 2001
Location: Eatonton, GA, USA
Posts: 191
|
Breather hole in Edelbrock valve covers
I'm going to order Elite valve covers for my Vortec heads tonight. Summit has them listed as left OR right side breather hole. Which should I get left side hole or right sidehole . Both covers have a hole so what do I need?
This picture shows a left side hole. |
|
|
|
10-16-2002, 03:56 PM
|
#2 |
|
Account Suspended
Join Date: May 2000
Location: IL
Posts: 0
|
best way to have it would be with hole in both covers, one toawrds front on one cover and one towards rear on other cover to make a crank case gs recirculation path through the engine.
one hole for vacuum, IE thew pcv valve and other for fittered return, and most all aftermarket covers have no oil filler hole/cap so theres another thing to think on. hope i helped, good luck |
|
|
|
|
10-16-2002, 04:44 PM
|
#3 |
|
Registered User
Join Date: Oct 2002
Location: enterprise kansas
Posts: 230
|
mines got a breather hole in both sides. one hooks to the breather for now until I finally quit pinching pennies and buy a crankcase breather for it. the other one hooks to the pcv valve. not sure exactly but arent they supposed to have a hole on both sides on these? if not ummmm theyre both the same you can always swap sides
__________________
71 chevy C10 LWB 2WD runs and everything 79 chevy 1/2 ton Big Ten silverado gonna part it out since it left me walking. 69 f100 real good shape with lots of go go juice 89 plymouth reliant (daily driver) 86 thunderbird sitting in the weeds almost covered (anyone need parts?) WWW.xschunkofthenet.freeservers.com nothing there I promise " tell me I'm a sinner I got news for you. I spoke to god this morning and he dont like you" OZZY |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
