![]() |
![]() |
#1 |
Registered User
Join Date: Aug 2002
Location: louisiana
Posts: 10
|
![]()
is it possible to use the front suspension from a 86 3/4 ton on a 68 1/2 ton? i know i can use the rearend with a conversion kithas anyone ever done this before?
__________________
71 c-10 in the works |
![]() |
![]() |
![]() |
#2 |
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
Yes, you should be able to bolt the complete crossmember from the 86 under the 68. There will be a couple bolt holes that need to be "egged out" . Good luck.....crazy longhorn
![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Aug 2002
Location: louisiana
Posts: 10
|
what i'm wanting to do is swap out the spindles and springs. is that possible?
__________________
71 c-10 in the works |
![]() |
![]() |
![]() |
#4 |
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
To swap the spindles, you need to replace the lower a arm (diff hole size on the balljoint), all 4 balljoints, tie rods, & center link. 71 up the centerlink & tie rods are different as far as lenghts on ends & sleeves, & hole sizes in the center link. i swapped my longhorn to a 1/2 ton using mid 70s parts, but alot of the guys are just swapping the complete assy to save on the parts mix. Good luck......crazy longhorn
![]() |
![]() |
![]() |
![]() |
Bookmarks |
|
|