Another Stupid 4x4 Question - Front Spindle 3/4 vs. 1/2??? - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

67-72williso · 11-25-2006, 09:27 AM

The Dana 44 front axle in your thuck should have 3.07 gears. That was standard with a "71" K-10 350 motor truck. To match them gears use a Dana 61 rear,they come in semi or full float. I got one out in the garage that I`m putting under a "72" K-10 chassis to 8 lug and match the 3.07 gears in the front.
Good luck!
Later Willis

msgross · 12-03-2006, 08:42 PM

I have a set of Dana 44 3/4 ton hubs that I will sell you, they should bolt right up and give you 8 lugs, all you should need is the backing plate, rotors, calipers and pads... let me know.

11-25-2006, 09:27 AM	#26
67-72williso Junk/Daily Driver Club Join Date: Feb 2004 Location: Manheim, PA 17545 Posts: 253	Re: Another Stupid 4x4 Question - Front Spindle 3/4 vs. 1/2??? The Dana 44 front axle in your thuck should have 3.07 gears. That was standard with a "71" K-10 350 motor truck. To match them gears use a Dana 61 rear,they come in semi or full float. I got one out in the garage that I`m putting under a "72" K-10 chassis to 8 lug and match the 3.07 gears in the front. Good luck! Later Willis __________________ Daily Driver: 1970 C-20 400 sbc,sm-465,Dana 61 one ton SRW rear, 3.07 gears, locker. There are three kinds of people: those who make things happen, those who watch things happen, and those who have no idea what happened! Last edited by 67-72williso; 11-25-2006 at 07:26 PM.

12-03-2006, 08:42 PM	#27
msgross Registered User Join Date: Jul 2006 Location: Central PA Posts: 12,201	Re: Another Stupid 4x4 Question - Front Spindle 3/4 vs. 1/2??? I have a set of Dana 44 3/4 ton hubs that I will sell you, they should bolt right up and give you 8 lugs, all you should need is the backing plate, rotors, calipers and pads... let me know.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.