WTB - ASAP = Rear End Yoke for a '71 K-10 (4x4 1/2t)

[arkracing]

I need a rear end yoke for a '71 K-10 (I'm assuming this is the 12bolt axle? - it is stock - don't know if 2wd's are the same or not..maybe you do???

Just the yoke - somebody must have run mine with bad u-joints for a while as the new u-joint is sloppy - the yoke cups are about .100" wider than the u-joint.

Yes - American made Precision Joints! - i'm pretty sure the yoke is worn (ever had that happen before?)

Let me know what you have.

Thanks,
Andy

[uncle]

I would think that it's a 12 bolt and if so any 12 bolt truck should work.

[arkracing]

Originally Posted by uncle

I would think that it's a 12 bolt and if so any 12 bolt truck should work.

thanks for the info. Yeh it probably is a 12 bolt. I don't know wtf it is to be honest - all i know is that the U-Joint doesn't fit - I stuck a couple of small washers in it for now just to hold the cups from sliding around (the truck isn't drivable @ this point anyway)

[ZOOMY]

You must not have the correct U-joint. Did it seat OK in the driveshaft side ?

[msgross]

will a front yoke off a Dana 44 work for ya?

[arkracing]

Originally Posted by ZOOMY

You must not have the correct U-joint. Did it seat OK in the driveshaft side ?

Fit's fine in the Driveshaft - fits fine on the transfer case
(they don't make a u-joint that is .100" longer on one axis than the other, the closest thing is a #134 U-joint which is about 1/4" longer on 1 axis and is way too long for the rear end yoke)
I did a post in the '67-'72 info board with some more info as well.
http://www.67-72chevytrucks.com/vboa...d.php?t=219132

D44 will be different

Pretty sure it has to be from a '71-'71 C or K 5-10

[Blazerb61]

I have that rear end yolk its about 1 1/2 years old Id take 50 for it plus the ride I paid over 80 for it

[arkracing]

Originally Posted by Blazerb61

I have that rear end yolk its about 1 1/2 years old Id take 50 for it plus the ride I paid over 80 for it

PM Sent