stepside bed mounting pads - The 1947 - Present Chevrolet & GMC Truck Message Board Network

whatnow123 · 12-23-2006, 01:34 PM

Hey Everyone

Can someone tell me how thick the rubber bed mounting pads are?

Sweet72 · 12-23-2006, 02:13 PM

This may sound a bit backwoods, but just get an old inner tube and cut some squares about 3X3 inches and cut a hole in them for the bolt to pass through. Works like a charm...

whatnow123 · 12-23-2006, 03:18 PM

Quote:

Originally Posted by Sweet72

This may sound a bit backwoods, but just get an old inner tube and cut some squares about 3X3 inches and cut a hole in them for the bolt to pass through. Works like a charm...

Thanks, that's what I thought, but wanted to check first.

**JDL** · 12-23-2006, 08:59 PM

I used an old slick

12-23-2006, 01:34 PM	#1
whatnow123 Registered User Join Date: Oct 2006 Location: Arizona Posts: 835	stepside bed mounting pads Hey Everyone Can someone tell me how thick the rubber bed mounting pads are?

12-23-2006, 02:13 PM	#2
Sweet72 Registered User Join Date: Nov 2003 Location: Alexandria, VA Posts: 1,534	Re: stepside bed mounting pads This may sound a bit backwoods, but just get an old inner tube and cut some squares about 3X3 inches and cut a hole in them for the bolt to pass through. Works like a charm... __________________ '72 GMC SWB C1500 Custom, frame-off in progress. 383 SBC, 9:1CR, Comp Cams XE262H, Scat internal balanced crank, Eagle SIR 6" rods, Keith Black dish pistons, Dart Iron Eagle 72/180 heads, Weiand Stealth intake, Stewart stage I water pump, Holley 4bbl vac sec, TH350 with B&M Shift Improver Kit. 12 bolt positraction.

12-23-2006, 08:59 PM	#4
JDL Senior Member Join Date: Sep 2000 Location: Agency IA. Posts: 1,839	Re: stepside bed mounting pads I used an old slick __________________ 72 Chevy short step side with 454 air and tilt. 72 nova project car 63 chevy II drag car Agency Iowa



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.