|
11-10-2002, 08:58 PM
|
#1 |
|
Registered User
Join Date: Nov 2002
Location: Spring TX
Posts: 113
|
mechanical guages
A time consuming task - what do ya'll think of this guage install?
http://www.oplnk.net/~spirit/guages.JPG
__________________
350 Crate 10 bolt 3.73 2.5 lift 32x11.50 1904 Edelbrock http://www.oplnk.net/~spirit/K5front.jpg |
|
|
|
11-10-2002, 09:52 PM
|
#2 |
|
yeller
Join Date: Oct 2001
Location: Twin Cities
Posts: 13,826
|
it would be better if all the gauges actually matched! Swerve has one of the best setups out there if you are looking for something like that.
-Jeff |
|
|
|
|
11-11-2002, 09:17 AM
|
#3 |
|
Registered User
Join Date: Jun 2002
Location: DFW, TX
Posts: 1,680
|
Not too bad I guess. It's better than my idiot lights!! But, I've seen alot better.
__________________
Scott Shelbourne |
|
|
|
|
11-11-2002, 01:56 PM
|
#4 |
|
Registered User
Join Date: Oct 2002
Location: Phoenix, Arizona
Posts: 4,703
|
I have all my gauges installed now (I needed to add tach). Well I might add two more where the upper dirver AC vent goes
 Anyway I will post pictures soon. My gauges are installed like Tom's are (in front of bezel). If I was to do it over again. I think I would go with Mike's type of install. Because you loose (3) screws in the process. Anyways the thing I like about my install is that you can see the grey ring around the gauges, I like that ring Kind of a toss up.
__________________
* AVOID: LOPER'S PERMORANCE / LOPERSPEED.COM OF PHOENIX, AZ & COTTMAN TRANSMISSION * |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
