|
01-18-2007, 01:57 PM
|
#1 |
|
Registered User
Join Date: Sep 2006
Location: Honea Path, SC
Posts: 90
|
Header Question
 I know this may have been asked before, but does anyone know what headers can be used on a 64 c10 with a 350 engine and 3 on the tree, and where they can be purchased.
|
|
|
|
01-18-2007, 03:21 PM
|
#2 |
|
Retrofit Management
Join Date: Apr 2006
Location: Las Vegas, NV
Posts: 73
|
Re: Header Question
Both Summit Racing and Jegs Performance list headers for your application... from basic painted steel to polished stainless or coated, you are only limited by your check book
__________________
My retrofit fleet -1966 Suburban 2002 Tahoe drivetrain, firewall, floor, chassis and interior in progress -1965 C-10 shortbed stepside, 2003 5.3/4L60E conversion. Power steering, tilt wheel, power front disc brakes, 2.5/4 inch drop, relocated fuel tank and battery, 2002 Silverado buckets and console. Swap Pics -1968 Camaro 95 LT1/4L60E lots o' mods Web Page -1961 Corvette project Corvette Corrections frame, C-4 suspension and brakes, 02 LS1/T-56, Never ending body workPics |
|
|
|
|
01-18-2007, 06:10 PM
|
#3 |
|
SIR
Join Date: Apr 2005
Location: grants pass oregon,usa
Posts: 658
|
Re: Header Question
I just went to my local parts store (kragen) picked a set of "flo-tec" coated headers got them over the counter didn't have to wait..musta got luckey....
__________________
66long low fleet http://community.webshots.com/user/LVNR66 Last edited by SIR; 05-06-2007 at 01:16 PM. |
|
|
|
|
01-19-2007, 09:32 AM
|
#4 |
|
Registered User
Join Date: Sep 2006
Location: Honea Path, SC
Posts: 90
|
Re: Header Question
Thanks guys for the quick response, and kwkenuf, if I can't locate at local parts house, will be in touch. I am wanting to finish all engine mods before spring , so she can go to paint, and I can enjoy making teens in this area green with envy. Thanks again.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
