|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-05-2007, 08:47 PM
|
#3 |
|
The One And Only !!!
Join Date: Jan 2007
Location: Hole in the woods Florida
Posts: 4,567
|
Re: Leak: What is it? Why? How do I fix it?
There is a small seal inside that speedo gear-head housing. The easiest way is jack the rear of the truck high and remove the cable then the gear-head housing. Slide the gear out of the housing then stick a small screw driver in place of the gear pushing the seal out. Be careful because there is a small wire ring holding the seal in place on the outside.
They do have tools to remove and re-install this seal without removing the gear-head housing but they are a bit expensive.
__________________
93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz !  The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. "Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
Last edited by Restrorob; 02-05-2007 at 08:53 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode