LFD's low buck truck build!

[hgs_notes]

Kevin, on the picture of your U bolt set up with the square tube block, shouldn't the axle tube be welded to the square tube to keep the axle from spinning?

Nice work BTW. I've been learning a lot watching your build threads and was even motivated enough the other day to pull the rusty driver fender off my ride. Need to do some clean up and rust proofing before installing the new one. Then its on to the running bords and floor.

Keep pushing us to do more with your positively non-stop ambition.

HG

[Rokcrln]

Originally Posted by hgs_notes

Kevin, on the picture of your U bolt set up with the square tube block, shouldn't the axle tube be welded to the square tube to keep the axle from spinning? HG

Yes it will once I figure out if I will run a one piece ot a two piece drive shaft. The pinion angle changes a bit depending on the type you use. But good catch!

Kevin
LFD inc.