Big 2.5" Vette Ram Manifolds---Fit 2WD! and 4WD - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**PICKMUP** · 04-04-2007, 12:23 PM

DP-There is no welding needed or done to the cast/manifolds...you just have to weld on the flares on the down pipes. Just cut off the ears and smooth the manifolds up with a hand grinder/sander for appearance. "DIY" and save.

MS-If you have holes in your heads, just run a 69+ alt brkt set...If not, you will have to get or make an aftermarket alt brkt. Yes you can have them ceramicoated or high temp painted. DIY and save.

04-04-2007, 12:23 PM	#6
PICKMUP "Trucks with Class" Join Date: Jul 2000 Location: OLYMPIA, WA, USA Posts: 8,213	Re: Big 2.5" Vette Ram Manifolds---Fit 2WD! and 4WD DP-There is no welding needed or done to the cast/manifolds...you just have to weld on the flares on the down pipes. Just cut off the ears and smooth the manifolds up with a hand grinder/sander for appearance. "DIY" and save. MS-If you have holes in your heads, just run a 69+ alt brkt set...If not, you will have to get or make an aftermarket alt brkt. Yes you can have them ceramicoated or high temp painted. DIY and save.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.