|
04-11-2007, 07:52 PM
|
#1 |
|
Registered User
Join Date: Aug 2006
Location: columbia, tn
Posts: 48
|
front suspention
the bar on the front suspention where the idler arm and pitman arm bolt on opposite ends bends like this
 but i don't remember which way it faces it would seem that it bends toward the back but i am not sure. |
|
|
|
04-11-2007, 08:38 PM
|
#2 |
|
Senior Member
Join Date: Jul 2005
Location: Winters Ca. 95694
Posts: 4,843
|
Re: front suspention
Is this the one you are talking about?
Kevin LFD Inc. |
|
|
|
|
04-11-2007, 08:42 PM
|
#3 |
|
Junior Member
 Join Date: Jun 2003
Location: Louisville,Ky
Posts: 387
|
Re: front suspention
Both the pitman and idler arm come into the center link from the top. The tie rods enter from the rear. All of these holes are tapered and you can only orient it one way.
|
|
|
|
|
04-11-2007, 08:49 PM
|
#4 |
|
Registered User
Join Date: Aug 2006
Location: columbia, tn
Posts: 48
|
Re: front suspention
hey thanks alot guys i had planned on doing the suspention today but it was raining so i was just going over the parts and trying to fit it together in my mind
once agian thanks |
|
|
|
|
04-12-2007, 10:48 AM
|
#5 |
|
Registered User
Join Date: Oct 2005
Location: Sacramento, CA
Posts: 1,970
|
Re: front suspention
It does bend towards the back and you can put it all together backwards......I should know!!
__________________
72 Cheyenne SWB Fleet Nut & bolt frame off in progress...99.9999% - supercharged 383 - 4 wheel discs - relocated fuel tank -  My Build Thread |
|
|
|
|
04-12-2007, 04:56 PM
|
#6 |
|
Junior Member
Join Date: Jun 2003
Location: Louisville,Ky
Posts: 387
|
Re: front suspention
Yes you can put it together backwards but not if the tie rods are coming in from the back of the drag link when in front of the truck. The bend is toward the front of the truck. When it is right there will be about 1/4-3/8 clearance between the front crossmember and the drag link.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
