fast grille removals for secret location - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Luvlegs · 05-03-2007, 01:13 PM

I searched around and couldn't find anything detailed enough...

HOPEFULLY Going this weekend to pick up a few grilles - I have to pull them though and have a limited amount of time. Perhaps someone will have an answer or two.

I am pulling a 71 outter/inner - there are rivets on it and bolts.... not sure where they are all at or what tools I might need.

I am also going to pull a 67 and 2 68-69s (one GM) - I started 2 of them but had to give up as I ran out of time and couldn't find all the danged connection points.

I have to walk quite a ways and fight through a jungle to get to them so I can't really carry or haul all my tools, a compressor, etc. I did manage to drill out and take home a sway bar and all the brackets... so I know it can be done (the grilles) but it was a pain. I just have to avoid pulling bumpers and fenders as it eats up time.

If anyone can tell me size, location, chisel, etc, I would appreciate it greatly.
(not just the grilles either but if there are any tricks to say, headlight buckets, fender parts of the grilles, etc)

I'm kinda in a race for time as I am swampped at work and home/momma/baby girl etc and don't have any experience with anything other than my 72 (and that's why I need one of the grilles! hahaha)
And I'm afraid my secret location will be discovered.....

powell72 · 05-03-2007, 09:46 PM

On 69-72's, drop the bumper, remove headlight bezels, unbolt the four (if I remember correctly) bolts attached to the latch and center support, remove the eight bolts that hold the outer grille brackets to the fenders and pull straight out. It will sneak out past the headlights. Don't mess with the rivots just leave the brackets on the grille. A wobble socket and long extension work good for getting those bolts, I believe they're 1/2''.

Luvlegs · 05-03-2007, 10:10 PM

MUCH appreciated! I was over thinking it and didn't even consider leaving the brackets attached... Now as for the 67s and 68s... and is there a center bolt at the bottom of the 68 gm grille? (I think it was a 68 - it had two marker lights at the bottom just above the bumper - seperate chrome on each fender and another thinner chrome strip across the top).... Again, any info is much appreciated and as you can tell by the time, my day has just finished up...

powell72 · 05-03-2007, 11:28 PM

Maybe somebody else will chime in on the 67/68's. I haven't had one of those for about eight years, I'm a little rusty on those.

AR15DEFENSE · 05-03-2007, 11:47 PM

be careful, last time I visited my "secret location" I was 16 and got arrested.

cstm68 · 05-03-2007, 11:53 PM

the 67-68s (two bolts on top and two bolts on bottom on bolth sides)=8
then i think theres 4 in the latch( 1 bottom 1 center and 2 on top) then 4 screws in each headlight bezzel.
then two nuts on each turn light or just dissconect the wires and pull thoes with the grille

RicksTrucks · 05-04-2007, 01:35 AM

On the 67-68, if you want to take the gravel pan too, they can be a bear since they are probably at the lowest point and get very rusty. The last one I pulled, I had the guy lift the truck up so that I could get to them. Another one was on two flat front tires, so I couldn't get to the bolts. When I came back later with a jack, the truck had been crushed.

cstm68 · 05-04-2007, 01:48 AM

Quote:

Originally Posted by RicksTrucks

On the 67-68, if you want to take the gravel pan too, they can be a bear since they are probably at the lowest point and get very rusty. The last one I pulled, I had the guy lift the truck up so that I could get to them. Another one was on two flat front tires, so I couldn't get to the bolts. When I came back later with a jack, the truck had been crushed.

oops forgot about that

Luvlegs · 05-04-2007, 08:41 AM

hmmmm like I said, I have to walk quite a ways to get to 'em..... and the 67s are flat on the ground (up to the frame)..... Thanks for the input guys... hopefully, this time tomorrow I am up to my elbows in 'em and I WILL be taking some pics....

05-03-2007, 01:13 PM	#1
Luvlegs Registered User Join Date: Sep 2005 Location: Smith Mountain Lake Virginia Posts: 1,537	fast grille removals for secret location I searched around and couldn't find anything detailed enough... HOPEFULLY Going this weekend to pick up a few grilles - I have to pull them though and have a limited amount of time. Perhaps someone will have an answer or two. I am pulling a 71 outter/inner - there are rivets on it and bolts.... not sure where they are all at or what tools I might need. I am also going to pull a 67 and 2 68-69s (one GM) - I started 2 of them but had to give up as I ran out of time and couldn't find all the danged connection points. I have to walk quite a ways and fight through a jungle to get to them so I can't really carry or haul all my tools, a compressor, etc. I did manage to drill out and take home a sway bar and all the brackets... so I know it can be done (the grilles) but it was a pain. I just have to avoid pulling bumpers and fenders as it eats up time. If anyone can tell me size, location, chisel, etc, I would appreciate it greatly. (not just the grilles either but if there are any tricks to say, headlight buckets, fender parts of the grilles, etc) I'm kinda in a race for time as I am swampped at work and home/momma/baby girl etc and don't have any experience with anything other than my 72 (and that's why I need one of the grilles! hahaha) And I'm afraid my secret location will be discovered..... __________________ "A cat will almost always blink when hit between the eyes with a ball peen hammer" (you don't always have to state the obvious) Wear your PPE! You can eat with false teeth but you can't see with a false eye. 1959 Studebaker Silverhawk 350/400 1972 C10 L6 3OTT 2005 F350 - Built - whew!

05-03-2007, 09:46 PM	#2
powell72 Senior Member Join Date: Jan 2005 Location: Loveland Co. Posts: 3,098	Re: fast grille removals for secret location On 69-72's, drop the bumper, remove headlight bezels, unbolt the four (if I remember correctly) bolts attached to the latch and center support, remove the eight bolts that hold the outer grille brackets to the fenders and pull straight out. It will sneak out past the headlights. Don't mess with the rivots just leave the brackets on the grille. A wobble socket and long extension work good for getting those bolts, I believe they're 1/2''. __________________ Chris 74 Custom Deluxe SWB 350/350/3.73’s 99 2wd Silverado RCSB 5.3/4L60/3.90’s http://www.classictrucks.com/feature...short_bed.html Last edited by powell72; 05-03-2007 at 09:56 PM.

05-03-2007, 10:10 PM	#3
Luvlegs Registered User Join Date: Sep 2005 Location: Smith Mountain Lake Virginia Posts: 1,537	Re: fast grille removals for secret location MUCH appreciated! I was over thinking it and didn't even consider leaving the brackets attached... Now as for the 67s and 68s... and is there a center bolt at the bottom of the 68 gm grille? (I think it was a 68 - it had two marker lights at the bottom just above the bumper - seperate chrome on each fender and another thinner chrome strip across the top).... Again, any info is much appreciated and as you can tell by the time, my day has just finished up... __________________ "A cat will almost always blink when hit between the eyes with a ball peen hammer" (you don't always have to state the obvious) Wear your PPE! You can eat with false teeth but you can't see with a false eye. 1959 Studebaker Silverhawk 350/400 1972 C10 L6 3OTT 2005 F350 - Built - whew!

05-03-2007, 11:28 PM	#4
powell72 Senior Member Join Date: Jan 2005 Location: Loveland Co. Posts: 3,098	Re: fast grille removals for secret location Maybe somebody else will chime in on the 67/68's. I haven't had one of those for about eight years, I'm a little rusty on those. __________________ Chris 74 Custom Deluxe SWB 350/350/3.73’s 99 2wd Silverado RCSB 5.3/4L60/3.90’s http://www.classictrucks.com/feature...short_bed.html

05-03-2007, 11:47 PM	#5
AR15DEFENSE Resident Absorber Join Date: Mar 2007 Location: WI Posts: 131	Re: fast grille removals for secret location be careful, last time I visited my "secret location" I was 16 and got arrested. __________________ The best offense is a better DEFENSE!

05-03-2007, 11:53 PM	#6
cstm68 Registered User Join Date: Jan 2007 Location: shoreline, wa Posts: 1,565	Re: fast grille removals for secret location the 67-68s (two bolts on top and two bolts on bottom on bolth sides)=8 then i think theres 4 in the latch( 1 bottom 1 center and 2 on top) then 4 screws in each headlight bezzel. then two nuts on each turn light or just dissconect the wires and pull thoes with the grille __________________ 68 swb fleet bagged on 20's 327 with 4 speed http://67-72chevytrucks.com/vboard/s...d.php?t=223308 2014 Chevy 2500hd duramax CCLB

05-04-2007, 01:35 AM	#7
RicksTrucks Senior Member Join Date: Jan 2005 Location: Claremore, OK 74017 Posts: 2,640	Re: fast grille removals for secret location On the 67-68, if you want to take the gravel pan too, they can be a bear since they are probably at the lowest point and get very rusty. The last one I pulled, I had the guy lift the truck up so that I could get to them. Another one was on two flat front tires, so I couldn't get to the bolts. When I came back later with a jack, the truck had been crushed. __________________ 68 Short Stepside C-10 69 SWB C-10 70 Flatbed C-20 70 LWB C-20 BB402 70 LWB C-10 CST 70 LWB C-10 CST 71 Short Stepside Cheyenne C-10 72 LWB C-10 72 Blazer 4x4 4spd 95 Jeep Cherokee 4x4

05-04-2007, 08:41 AM	#9
Luvlegs Registered User Join Date: Sep 2005 Location: Smith Mountain Lake Virginia Posts: 1,537	Re: fast grille removals for secret location hmmmm like I said, I have to walk quite a ways to get to 'em..... and the 67s are flat on the ground (up to the frame)..... Thanks for the input guys... hopefully, this time tomorrow I am up to my elbows in 'em and I WILL be taking some pics.... __________________ "A cat will almost always blink when hit between the eyes with a ball peen hammer" (you don't always have to state the obvious) Wear your PPE! You can eat with false teeth but you can't see with a false eye. 1959 Studebaker Silverhawk 350/400 1972 C10 L6 3OTT 2005 F350 - Built - whew!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.