4WD to 2WD frame swaps - The 1947 - Present Chevrolet & GMC Truck Message Board Network

onetonk5 · 05-14-2007, 08:24 PM

I will be doing a front crossmember swap and add trailing arms as soon as I get a little farther along with the rust repair. Any more info is greatly appreciated...What bolt hole lines up with the trailing arm crossmember? Did you do a c notch? Panhard bar or something else?? Im considering a watts linkage to keep the rear centered during travel.

gringoloco · 05-15-2007, 01:08 AM

Quote:

Originally Posted by onetonk5

I will be doing a front crossmember swap and add trailing arms as soon as I get a little farther along with the rust repair. Any more info is greatly appreciated...What bolt hole lines up with the trailing arm crossmember? Did you do a c notch? Panhard bar or something else?? Im considering a watts linkage to keep the rear centered during travel.

Check my thread linked above. There are pictures detailing exactly where to place the center crossmember to have the rear axle centered...

05-14-2007, 08:24 PM	#1
onetonk5 Cereal Killer Join Date: Jan 2006 Location: Montgomery, Alabama Posts: 639	Re: 4WD to 2WD frame swaps I will be doing a front crossmember swap and add trailing arms as soon as I get a little farther along with the rust repair. Any more info is greatly appreciated...What bolt hole lines up with the trailing arm crossmember? Did you do a c notch? Panhard bar or something else?? Im considering a watts linkage to keep the rear centered during travel. __________________ If I dont do it....somebody else will.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.