|
05-28-2007, 06:42 PM
|
#1 |
|
It's the air up here
Join Date: Mar 2007
Location: Western Colorado
Posts: 710
|
cargo lamp trouble
My cargo lamp wasnt working, so I takes it apart to check bulb, wiring. I think bulb is bad, but putting it back together was a pain in the @#*. Has two steel spacers on the screws and rubber grommets with nuts in the back attached to the cab, and one of the nuts just spins but wont tighten. Have you guys seen this set up? Where can I get new grommets? Help! If I dont get it tight then it will leak water into the cab.... Rust.....
__________________
1971 cheyenne k10 4 speed np 205 454 BB factory a/c  Never drink down stream of the herd! Eric |
|
|
|
05-28-2007, 07:40 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: cargo lamp trouble
I believe most of the vendors have the nuts. I got mine from the local ACE Hardware along with new SS screws.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
