68 K-10 SWB build thread - project Money Pit...pics galore! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

msgross · 06-15-2007, 01:54 AM

so I picked up my $75 in seals and bearings from napa the other day. The Junkyard 12 bolt posi was leaking oil out the pinion like a New Orleans levee....

The corp 10 front axle had crusty needle bearings and bad seals too....

Also a pic of the read add-a-leaf installed. Added 1.5" to the leaf pac before installation.

New rea wheel studs where in order since I could only get 6 turns on the lugs with the MT's installed. These are 1/4 longer. Whats the best way to install? press, or just tighten down a lug nut to pull it tight?

06-15-2007, 01:54 AM	#11
msgross Registered User Join Date: Jul 2006 Location: Central PA Posts: 12,201	Re: 68 K-10 SWB build thread - project Money Pit...pics galore! so I picked up my $75 in seals and bearings from napa the other day. The Junkyard 12 bolt posi was leaking oil out the pinion like a New Orleans levee.... The corp 10 front axle had crusty needle bearings and bad seals too.... Also a pic of the read add-a-leaf installed. Added 1.5" to the leaf pac before installation. New rea wheel studs where in order since I could only get 6 turns on the lugs with the MT's installed. These are 1/4 longer. Whats the best way to install? press, or just tighten down a lug nut to pull it tight? Attached Images __________________ The Garage: 1968 K-10 SWB - "Project Money Pit" 1996 Z-71 - "huntin rig" 1969 C-10 LWB (SOLD) "Project flip that truck or else" 1993 Passport, F@rd 1-ton (SOLD)"Project Cousin Eddie" My Garage Build "The 1,000 footer" Last edited by msgross; 06-15-2007 at 01:56 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.