|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-25-2007, 10:43 AM
|
#3 |
|
Registered User
Join Date: Apr 2000
Location: Chester County PA, USA
Posts: 1,228
|
Re: Tools for a front dana44 rebuild
snap ring pliers would be nice. And if you dont have the bushing drivers, a hammer and a brass punch would work. The spindle nut socket is a must. I have used a small punch and a hammer to remove the spindle nut, but it boogers them up and you cant torque them. A ball joint fork and a ball joint press is needed too. And a torque wrench if you wanta get it right for reassembly. Thats all i can think of right now.
And the adjusting sleeve socket too.
__________________
72 k/10 short wideside 72 k/5 Blazer 72 K/5 Blazer - obstacle course racer 72 custom/10 8' bed 70 K/5 Blazer 67 C-30 GMC Flat bed 86 GMC K2500 Plow Truck 85 GMC K3500 84 M1008 85 M1008 77 G30 Motor Home 72 Sears 12hp Tractor Glenmoore, Pennsylvania Last edited by OLDCHEV4X4; 06-25-2007 at 11:01 AM. |
|
|
| Bookmarks |
|
|
Threaded Mode