|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-03-2007, 11:41 AM
|
#1 |
|
Registered User
Join Date: Jun 2007
Location: Hayden Alabama
Posts: 159
|
Rear C-Notch and Shaft Loop
Where's the best place/price to get pre-fabbed rear c-notches? Also, I'm wondering about my forward cross member that the drive shaft goes through. I'm afraid that my drive shaft will hit the top of the loop if I lower the truck more. Any ideas on modifying this cross member?
|
|
|
|
07-03-2007, 01:38 PM
|
#2 |
|
Licensed to Thrill!
Join Date: Apr 2006
Location: Northwest, GA
Posts: 1,673
|
Re: Rear C-Notch and Shaft Loop
I think CPP is about the cheapest on the rear C-Notches.
DLB |
|
|
|
|
07-03-2007, 02:04 PM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Re: Rear C-Notch and Shaft Loop
ECE has both of your concerns covered.....
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
07-03-2007, 07:21 PM
|
#4 |
|
Scrapper 1
Join Date: Jan 2007
Location: Riverside Calif
Posts: 1,649
|
Re: Rear C-Notch and Shaft Loop
i have a good Fix for ya i have a 1968 GMC 3 door suburban and it was C notched and channled and lowered just look
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
