|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-08-2007, 12:50 AM
|
#1 |
|
Registered User
Join Date: Dec 2004
Location: Saskatchewan, Canada
Posts: 1,371
|
Plug Gap for Stock-ish 350?
I'm just about to replace the plugs in my truck while they're easily accessible (No fenders) and I realized I should check/gap them. They are Delco plugs, can't remember the number, but they are the factory replacements for my engine, an early 80's suburban motor. It's just a plain old smog-era 350 with an Edelbrock performer carb and intake, HEI, and ramhorn manifolds. Any idea what they should be gapped at, or is more info needed? Also, how tight do I tighten them into the head? I've always just done it by feel, but is there an actual FT/LBS rating, since I have the room for a torque wrench? Thanks!
__________________
1964 Chevy Short Fleet: Tornado 1972 Chevy C10: Fast Orange Secondaries Wide Open |
|
|
|
08-08-2007, 05:44 AM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Plug Gap for Stock-ish 350?
,045 pluggap for hei
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
08-08-2007, 08:44 AM
|
#3 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,593
|
Re: Plug Gap for Stock-ish 350?
x2
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
08-08-2007, 11:49 AM
|
#4 |
|
Registered User
Join Date: Dec 2004
Location: Saskatchewan, Canada
Posts: 1,371
|
Re: Plug Gap for Stock-ish 350?
Thanks guys!
__________________
1964 Chevy Short Fleet: Tornado 1972 Chevy C10: Fast Orange Secondaries Wide Open |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
