|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-07-2007, 02:25 PM
|
#1 |
|
Registered User
 Join Date: Feb 2004
Location: Groton, CT
Posts: 168
|
Lower Control Arm Shaft Nuts
I found the torque specs for the upper control arm shaft nuts on my C10 Chevy but my manual doesn't give the specs for the lower control arm shaft nuts. If anyone has that info I would really appreciate you sharing it with me.
Jim |
|
|
|
09-07-2007, 07:51 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Lower Control Arm Shaft Nuts
The lower control arm bushings are torqued to 160 lb./ft. (new) or 95 lb./ft. (replace) per the overhaul manual.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
09-08-2007, 06:55 AM
|
#3 |
|
Registered User
Join Date: Feb 2004
Location: Groton, CT
Posts: 168
|
Re: Lower Control Arm Shaft Nuts
Thanks for the info, now I can get on with my front end replacement. When you say replace does that mean just puting a new nut on the existing shaft? I'm putting new shafts and nuts so I assume the "new" torquee spec applies.
Last edited by bossrod; 09-08-2007 at 06:57 AM. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
