|
09-12-2007, 10:07 PM
|
#1 |
|
Registered User
Join Date: Feb 2006
Location: San Diego
Posts: 631
|
How low can I go
How low can I go with stock spindles? I would like to go as low as possible with everything stock no cutting. Front and rear
|
|
|
|
09-13-2007, 07:30 AM
|
#2 |
|
67-72 Addict!
Join Date: Feb 2002
Location: The TAX State!
Posts: 7,856
|
Re: How low can I go
In your case i would think about going 3" front springs and 5" rear springs. I've cut 1.25 coils off existing front coils to get the 3" drop and buy a set of rears cuz you can't cut them. Lower your whole truck for about $100 or just buy both sets new.
__________________
Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads |
|
|
|
|
09-13-2007, 05:37 PM
|
#3 |
|
Registered User
Join Date: Mar 2007
Location: Montgomery, Al.
Posts: 289
|
Re: How low can I go
http://www.67-72chevytrucks.com/vboa...d.php?t=257375
Check the link above. That is how low I went. I actually cut too much off the front springs, but it gave me the look I wanted. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
