|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-19-2007, 10:54 AM
|
#1 |
|
Registered User
Join Date: Aug 2005
Location: Mid MI
Posts: 67
|
Air Bags with DJM Tubular Lowers
Has anybody installed an air bag system with DJM 3" LCA's? If so, any modifications needed? Also, are there any rack & pinion kits available without changing the crossmember? This site is the best source of information on the net, (for our trucks) so I'll ask the members for their input. Thanks in advance for any info submitted.
|
|
|
|
09-19-2007, 04:01 PM
|
#2 |
|
Registered User
Join Date: Jul 2005
Location: Riverside CA
Posts: 860
|
Re: Air Bags with DJM Tubular Lowers
you probably have to plate the lowers and then drill a hole to center and mount the bag. you should ask in the suspension section.
|
|
|
|
|
09-19-2007, 08:27 PM
|
#3 |
|
It'd be alot cooler if you did
Join Date: May 2003
Location: Three Rivers, MI
Posts: 2,345
|
Re: Air Bags with DJM Tubular Lowers
I have done it. I completely cut off the lower buckets and just put a flat plate across it. If I had it to do over again I would probably put a litle bit of an angle on it for better bag alignment at lower ride heights, but I have had zero issues with my set up.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
