I couldn't take it anymore (rollbar)

[jaros44sr]

Originally Posted by jkade

If I where going to do one I would try to make it look like this.Attachment 307791

JKade, you read my mind. If and when I build my roll bar Ithnk it should be more oval to match up with the body lines. That being said, does the wall thickness have to be the same as a conventional roll bar??

[bouncytruck]

Originally Posted by jaros44sr

JKade, you read my mind. If and when I build my roll bar Ithnk it should be more oval to match up with the body lines. That being said, does the wall thickness have to be the same as a conventional roll bar??

Couldn't you do a "skin" around a conventional roll bar.

[jaros44sr]

Originally Posted by bouncytruck

Couldn't you do a "skin" around a conventional roll bar.

You could, but I was thinking the ease of bending sheet metal as opposed to a pipe bender. Plus I could tie it into my 'B' post and support the bottom to my frame. Kinda like tranmitting the load all the way down and to my frame. I think present day technology says .125 wall thickness

Ther was a guy over on CK5, that went into theory of a round pipe as opposed to a square, short version, round handles side impact better than square

This guy lost me after the first post, heavy heavy stuff. This guy is a genius, so who am I to question his thoughts

[kyle4381]

I was wondering when it would be removed.. Good choice.. looks much better