|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-26-2007, 07:47 AM
|
#1 |
|
Registered User
Join Date: Apr 2003
Location: Easley, South Carolina
Posts: 491
|
Pitman Arm to Drag Link Torque?
What do you torque do you apply to the nut that holds the drag link onto the tapered shaft of the pitman arm?
__________________
Richard Dobson |
|
|
|
12-26-2007, 08:34 AM
|
#2 |
|
Msgt USAF Ret
  
Join Date: Jan 2005
Location: Kalamazoo, Michigan
Posts: 8,718
|
Re: Pitman Arm to Drag Link Torque?
My Haynes manual says Pitman arm to relay rod nut is 60 ft lbs.
__________________
VetteVet metallic green 67 stepside 74 corvette convertible 1965 Harley sportster 1995 Harley wide glide Growing old is hell, but it beats the alternative. |
|
|
|
|
12-26-2007, 01:58 PM
|
#3 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,630
|
Re: Pitman Arm to Drag Link Torque?
If you are talking about the 1-5/16 nut on the sector shaft, then 150-180 should do the trick
|
|
|
|
|
12-29-2007, 02:22 PM
|
#4 |
|
Registered User
Join Date: Apr 2003
Location: Easley, South Carolina
Posts: 491
|
Re: Pitman Arm to Drag Link Torque?
The nut on my sector shaft is 15/16 and it is not a castle nut with a cotter pin. It is a locking nut with deformations on the side of the hex.
__________________
Richard Dobson |
|
|
|
|
12-31-2007, 02:12 PM
|
#5 |
|
Registered User
Join Date: Apr 2003
Location: Easley, South Carolina
Posts: 491
|
Re: Pitman Arm to Drag Link Torque?
So for my application the torque is 150-180 ft./lbs. since I don't have a castle nut with a cotter pin? Thanks
__________________
Richard Dobson |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
