|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-19-2008, 01:33 AM
|
#1 |
|
Senior Member
 
Join Date: Sep 2001
Location: Seattle, WA, USA
Posts: 5,817
|
Question about heater control cables...
how the heck do I route them? They're stiff as he'll. The long one (heat) is easy, but the middle one is bound up where it goes past the dash vent hose.
This is a non-ac truck.
__________________
'69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA. |
|
|
|
01-19-2008, 05:47 AM
|
#2 |
|
The Older Generation
  
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,772
|
Re: Question about heater control cables...
-
Are you sure you have them routed correctly? Here is a link to a thread on it. You need to lube them before you install them too. http://67-72chevytrucks.com/vboard/s...=heater+cables LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
|
|
|
01-19-2008, 09:03 AM
|
#3 |
|
Senior Member
Join Date: Sep 2001
Location: Seattle, WA, USA
Posts: 5,817
|
Re: Question about heater control cables...
yep, I lubed them up before I installed them. I ran them the same way as in the pic too, and they work fine, but I had to bend that middle one around slot to get it to reach. I also had to wrestle with the vent hose, so I got to thinking it was wrong.
__________________
'69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
