|
01-23-2008, 07:03 AM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: PENDLETON,INDIANA
Posts: 271
|
Amp Gauge
Hey All Gotta Question
I Have A 72gmc Jimmy 4x4 350 Auto And My Alternator Was Changed To A Internal Regulated By The Previous Owner Havent Found His Repair At The External Regulator But My Amp Gauge Shows Discharge At All Times (except At Key Off) I Read Somewhere That The Small Wire Off Of Alternator Goes To Volt Gauge So Does This Dude Have My Amp Gauge Reading Volts?? I Havent Gotten Too Deep Into It Yet Thought I Would Get Some Ideas Before I Get To It The Prev Owner Wasn't Much Of A Mechanic And Do You Really Run All Of The Currrent From The Alternator For The Whole Truck Through The Gauge?? Im Lost No Fires Please Lol... |
|
|
|
01-23-2008, 10:15 AM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Amp Gauge
The amp meter on these trucks read the flow of electricity based on wire resistance over a length of about 3 feet so only a very small amount of power goes through the gauge.
I would suggest hooking a volt meter to your battery with the engine running. Voltage should read approximately 14.5 volts if the alternator is charging. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
01-23-2008, 11:03 AM
|
#3 |
|
Registered User
Join Date: Jan 2008
Location: PENDLETON,INDIANA
Posts: 271
|
Re: Amp Gauge
I Forgot To Add That To Original Message
At Batt I Am At 14.5-15 Volts So Im All Good There |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
