Question about 700R tranny - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Mixup · 01-02-2008, 01:24 PM

There are 3 different tailshaft lengths on the 350. 6"-9"-12". If you have the 9" the 700r will use the same driveshaft. I think our trucks came with the 6" 350 unless someone changed it.

RicksTrucks · 01-26-2008, 04:43 PM

Would a 700r from an 87 2.8L V-8 work? I was thinking I may have read something about a 2.8L not bolting up to a 350 V8

68C15 · 01-26-2008, 09:18 PM

Quote:

Originally Posted by RicksTrucks

Would a 700r from an 87 2.8L V-8 work? I was thinking I may have read something about a 2.8L not bolting up to a 350 V8

you DO NOT want that one. even if it bolted up (I doubt it will) it is total junk. they dont even hold up to a 2.8.

01-02-2008, 01:24 PM	#26
Mixup Registered User Join Date: Jan 2002 Location: Henderson, NV Posts: 358	Re: Question about 700R tranny There are 3 different tailshaft lengths on the 350. 6"-9"-12". If you have the 9" the 700r will use the same driveshaft. I think our trucks came with the 6" 350 unless someone changed it. __________________ 1980 Chevy Shortbed Pickup 1969 Z28 engine Turbo 350

01-26-2008, 04:43 PM	#27
RicksTrucks Senior Member Join Date: Jan 2005 Location: Claremore, OK 74017 Posts: 2,639	Re: Question about 700R tranny Would a 700r from an 87 2.8L V-8 work? I was thinking I may have read something about a 2.8L not bolting up to a 350 V8 __________________ 68 Short Stepside C-10 69 SWB C-10 70 Flatbed C-20 70 LWB C-20 BB402 70 LWB C-10 CST 70 LWB C-10 CST 71 Short Stepside Cheyenne C-10 72 LWB C-10 72 Blazer 4x4 4spd 95 Jeep Cherokee 4x4



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.