bagged 68 need help with the drive shaft - The 1947 - Present Chevrolet & GMC Truck Message Board Network

azfab · 02-09-2008, 04:46 PM

ok the truck is some what done but at low speeds i have a wobble, i think its the drive shaft angle at ride highth its @3 degrees uphill. i was told to have it @ 3 to 5 degrees is that right? thanx for your input.

TravisH · 02-09-2008, 05:35 PM

Its about the relative angle to the output shaft on your transmission. If your rear is 3 degree up you want your tranny 3 degrees down

shifty · 02-10-2008, 03:36 AM

Check out this page, it helped me figure out what I need to do, so I bookmarked it and saved it for just such an occasion:

http://www.2quicknovas.com/happypinions.html

02-09-2008, 04:46 PM	#1
azfab Registered User Join Date: Aug 2007 Location: lodi ca Posts: 251	bagged 68 need help with the drive shaft ok the truck is some what done but at low speeds i have a wobble, i think its the drive shaft angle at ride highth its @3 degrees uphill. i was told to have it @ 3 to 5 degrees is that right? thanx for your input.

02-09-2008, 05:35 PM	#2
TravisH Registered User Join Date: Mar 2005 Location: Alberta Posts: 316	Re: bagged 68 need help with the drive shaft Its about the relative angle to the output shaft on your transmission. If your rear is 3 degree up you want your tranny 3 degrees down

02-10-2008, 03:36 AM	#3
shifty Questionable Join Date: Mar 2005 Location: Atlanta Posts: 13,373	Re: bagged 68 need help with the drive shaft Check out this page, it helped me figure out what I need to do, so I bookmarked it and saved it for just such an occasion: http://www.2quicknovas.com/happypinions.html __________________ If I've got anything up for grabs, it'll be here: 7-hole gauge cluster for a 67-72 p/u FREE (link) I can't check the forum daily. If I don't reply to you within 24 hours, drop me a PM! I'm (hopefully) still alive and will reply faster to a PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.