|
02-16-2008, 01:30 PM
|
#1 |
|
Registered User
Join Date: Oct 2003
Location: San Jose Ca.
Posts: 3,339
|
Heater Cables
When you install new heater controls do you need to position the heater cables out to their starting point? To be able to match the starting point on the heater controls?
__________________
RIP to my son Dylan. 5/17/2002 - 8/18/2018 If you want to know more about rare forms of pediatric cancer or if you want to help fund pediatric cancer research, please check out the website for the non-profit I started. https://slothforpedcancer.org 68 build thread http://67-72chevytrucks.com/vboard/s...d.php?t=223234 |
|
|
|
02-16-2008, 08:04 PM
|
#2 |
|
Registered User
 
Join Date: Sep 2007
Location: Fairdale, Kentucky
Posts: 561
|
Re: Heater Cables
OK I have read your question serveral times and I believe that I know what you mean. You're asking if they ned to be either fully on or off to be able to mount them.
The answer is NO you don't. But it may be easier install. as long as you mount them so that the push pull of the lever gives them proper travel. once they are hooked up and the control is mounted back in the dash they should all move to the correct location with the slide lever and even out. At least this has been my experience. Good luck with your install... Regards! |
|
|
|
|
02-16-2008, 10:52 PM
|
#3 |
|
Registered User
Join Date: Oct 2003
Location: San Jose Ca.
Posts: 3,339
|
Re: Heater Cables
I was kinda tired when I asked that one. I had to read it 1-2 times myself to find out what I asked LOL. Will do and thanks
__________________
RIP to my son Dylan. 5/17/2002 - 8/18/2018 If you want to know more about rare forms of pediatric cancer or if you want to help fund pediatric cancer research, please check out the website for the non-profit I started. https://slothforpedcancer.org 68 build thread http://67-72chevytrucks.com/vboard/s...d.php?t=223234 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
