AC dash install questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Huck · 02-26-2008, 07:25 PM

U have 2-3 bolts on both side--then using any kind of a cutter--just slice the leading edge behind the pad allowing enough metal to overlap or butt up. You will have a little cutting issue at both corners where you unbolted but--it's a whole lot easier then full repl and once done, the pad covers the tac welds perfectly. I've done several---. Pretty easy.

Jtrux · 02-26-2008, 09:17 PM

That's pretty cool, looks like i'll def have to go back and get one now, I thought it was a lot more work than that.

02-26-2008, 07:25 PM	#1
Huck Senior Member Join Date: Jun 2001 Location: Shelbyville, KY Posts: 3,261	Re: AC dash install questions U have 2-3 bolts on both side--then using any kind of a cutter--just slice the leading edge behind the pad allowing enough metal to overlap or butt up. You will have a little cutting issue at both corners where you unbolted but--it's a whole lot easier then full repl and once done, the pad covers the tac welds perfectly. I've done several---. Pretty easy.

02-26-2008, 09:17 PM	#2
Jtrux I'm a poor spectator Join Date: Aug 2006 Location: San Antonio, Tx Posts: 2,287	Re: AC dash install questions That's pretty cool, looks like i'll def have to go back and get one now, I thought it was a lot more work than that. __________________ 2006 Jeep Unlimited IMPACT ORANGE 1993 Chevy 2500 4x4 ExCab LWB 454/NV4500 Tow rig 1977 Ford F100 2x4 LWB 1st truck I owned, still have it!!! 1979 Ford F150 4x4 SWB Built Ford Tough!!! 1971 Chevy Blazer 350 / SM465 / NP205 UNDER CONSTRUCTION Soon to have a LQ4 6.0!!!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.