|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-28-2008, 09:19 AM
|
#1 |
|
Registered User
Join Date: Dec 2007
Location: Southern CA
Posts: 210
|
Steering Wheel Removal
Looking for some tricks on how to break loose a steering wheel from my 71.
Already tried: - Steering wheel puller - PB blaster - Pressure with a smack from a hammer Any ideas are welcomed as I will attempt them all until I succeed. Thank you, Mark |
|
|
|
02-28-2008, 09:38 AM
|
#2 |
|
yes, i do
Join Date: Jun 2007
Location: Spokane, wa
Posts: 2,734
|
Re: Steering Wheel Removal
did you try hitting the big screw that applies all the pressure?? i had to do that once or twice and it worked out fairly well. i would also soak the collumn shaft that the steering wheel fits on to for a bit longer. but i would definately try smacking the center screw of the steering wheel puller. get the screw to where you can't turn it anymore, smack the screw with a hammer, and it should come loose. lather, rinse, repeat till it comes off.
__________________
ERROR 404....... SNAPPY COMEBACK NOT FOUND  _______________________________________________________________________________________________ -60 Chevy C10, dead 350/good th350 combo, sitting on a 76 c10 blazer frame, built from 11 different vehicles "the abomination" -07 gmt900 silverado 1500 lt xcab z71, granite blue -81 suzuki gs650g "shelah"- current project -81 kz1000m1 csr "sarge" -next project (just beautification) -07 kawasaki vulcan classic vn900 |
|
|
|
|
02-28-2008, 06:28 PM
|
#3 |
|
Registered User
Join Date: Dec 2002
Location: Ludlow,MA
Posts: 145
|
Re: Steering Wheel Removal
put pressure on the wheel w/knees and 1 hand and hit the stud w/a brass or lead hammer
bob |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
