|
03-14-2008, 02:45 AM
|
#1 |
|
Registered User
Join Date: May 2006
Location: So.Cal
Posts: 542
|
Header question
Hi,
I am puttting a new 350 in the truck. I found out that I have a cracked exhaust manifold. I have a set of 1967 camaro headers in the garage... both are setup for an auto... can I bolt these on to the truck? David Last edited by djw32; 03-14-2008 at 08:52 PM. |
|
|
|
03-14-2008, 03:03 AM
|
#2 |
|
Registered User
 
Join Date: Jan 2005
Location: Illinois
Posts: 1,006
|
Re: Header question
I tried it and they didn't drop low enough and were dead center on in height with the trans crossmember...
|
|
|
|
|
03-14-2008, 03:31 AM
|
#3 |
|
Registered User
Join Date: May 2006
Location: So.Cal
Posts: 542
|
Re: Header question
Did they hit the trans crossmember? I can make an exhaust pipe go around it...i think.
|
|
|
|
|
03-14-2008, 08:52 PM
|
#4 |
|
Registered User
Join Date: May 2006
Location: So.Cal
Posts: 542
|
Re: Header question
ttt
|
|
|
|
|
03-14-2008, 09:39 PM
|
#5 |
|
Registered User
Join Date: May 2006
Location: Jonesboro, AR
Posts: 916
|
Re: Header question
I think they would also be in the way of the auto linkage. My son's truck has camaro headers and we replaced the linkage with a lokar cable. Made a custom crossmember to clear the exhaust but I'm sure it's far enough back that you might get some bends. 6-8" or so.
Last edited by 71tahoe; 03-14-2008 at 09:55 PM. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
