|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-14-2008, 05:19 PM
|
#1 |
|
Registered User
Join Date: Dec 2006
Location: kansas city, mo
Posts: 30
|
Quick Intake Bolt Question
It has been a ridiculously long time since I took my intake off my truck due to a broken bolt when attempting to remove the water pump. I got everything polished and painted and wanted to order a new set of ARP bolts to put it back on. I could have swore that there was more than one length of bolt used for the intake whenever I took it off. Am I crazy? From searching the forums I see that the factory length is 1 1/4" and looking at Summit's website, all the bolts look to be one length. If someone could just confirm that I don't need anything special depending on whether I have AC or some other options, I would really appreciate it.
|
|
|
|
03-14-2008, 05:50 PM
|
#2 |
|
knuckle buster..
 
Join Date: Oct 2007
Location: Frisco
Posts: 613
|
Re: Quick Intake Bolt Question
yep, all the same length.
__________________
_______________________________________________________________________________ Eric THIS SITE ROCKS!!!  Check out my suburban on 20's with fresh paint! Click here to support the site Check out the Member Photo Gallery here StreetCruizin FAQ thread Site vendors list (scroll down to vendors in red)  join the the smilies fight club
|
|
|
|
|
03-14-2008, 05:55 PM
|
#3 |
|
Registered User
Join Date: Dec 2006
Location: kansas city, mo
Posts: 30
|
Re: Quick Intake Bolt Question
Thanks for the quick reply.
|
|
|
|
|
03-14-2008, 06:02 PM
|
#4 |
|
knuckle buster..
Join Date: Oct 2007
Location: Frisco
Posts: 613
|
Re: Quick Intake Bolt Question
no prob!
__________________
_______________________________________________________________________________ Eric THIS SITE ROCKS!!! Check out my suburban on 20's with fresh paint! Click here to support the site Check out the Member Photo Gallery here StreetCruizin FAQ thread Site vendors list (scroll down to vendors in red) join the the smilies fight club
|
|
|
|
|
03-14-2008, 06:37 PM
|
#5 |
|
Senior Member
Join Date: Jun 2001
Location: Shelbyville, KY
Posts: 3,269
|
Re: Quick Intake Bolt Question
Use bolt thread sealer or you may have coolent leak up the bolt hole onto the intake.
|
|
|
|
|
03-15-2008, 03:55 PM
|
#6 |
|
Registered User
Join Date: Dec 1999
Location: Old Mission, MI, USA
Posts: 2,510
|
Re: Quick Intake Bolt Question
The original A/C compressor bracket bolted to the two front intake bolts on the passenger side, so longer bolts were used in that spot on trucks with air.
__________________
Tim |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
