|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-19-2008, 01:11 AM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: Russellville
Posts: 47
|
Replacing gear position indicator
I'm about to replace my gear position indicator and i was wondering where the little clip piece on the end of the cord goes? anyone know?
|
|
|
|
04-19-2008, 01:26 AM
|
#2 |
|
Registered User
Join Date: Oct 2006
Location: iowa
Posts: 722
|
Re: Replacing gear position indicator
on the steering column right below the indicator.... there should be a plastic shrouf that ends right near there....slide the clip over the edge of that and then move it up or down so that it is in the right spot for the gear you are in
__________________
"Horsepower is how fast you hit the wall, torque is how far you carry the wall with you." '84 chevy half ton short box 2wd, 67,000 actual miles  '03 chevy 1500 HD crew cab 4x4 standard box, 6.0L 
|
|
|
|
|
04-19-2008, 01:33 AM
|
#3 |
|
Registered User
Join Date: Nov 2007
Location: Inman,SC
Posts: 93
|
Re: Replacing gear position indicator
 clips on the part near the selector needle that rotates when you use the shifter...
__________________
1984  sierra classic (daily driver)1986 sierra classic (garage dust collector)1986 silverado (garage dust collector)
Last edited by lawson86; 04-19-2008 at 01:36 AM. |
|
|
|
|
04-20-2008, 05:32 PM
|
#4 |
|
Registered User
Join Date: Jul 2004
Location: ashland oh
Posts: 660
|
Re: Replacing gear position indicator
clip on mine was broke,held in place with screw
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
