|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-19-2008, 05:04 AM
|
#1 |
|
Registered User
 
Join Date: Apr 2004
Location: Sacramento
Posts: 3,737
|
pictures of double wall top needed.
I need a picture of the window opening for a double wall top. I'm trying to see if the front window rubber is the same as my half top, because it looks a little different than my single wall top. The window rubber is different between a single and a double, right?
__________________
'72 2wd blazer, bagged w/ watts link & EDC '72 C10 "Lowered Farm Truck" STOLEN 5-18-11 '66 impala ht |
|
|
|
05-19-2008, 01:42 PM
|
#2 |
|
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,475
|
Re: pictures of double wall top needed.
Are you talking about the rubber/seals for your roll up windows? IIRC the only
rubber differances between a single and a double are the side windows. Again, IIRC. I believe that the rear hatches are the same, front seals, and rain caps are all the same on both singles and doubles. (I had both and never saw any differance between them.) Although I can't confirm, just what I remember. 
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Big Piggy: "Goliath" 07 Kodiak C4500 Lil Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
|
|
|
05-19-2008, 08:09 PM
|
#3 |
|
Registered User
Join Date: Apr 2004
Location: Sacramento
Posts: 3,737
|
Re: pictures of double wall top needed.
I talking about the seal between the rear and upper portion of the window, and the top. When the window is rolled up.
__________________
'72 2wd blazer, bagged w/ watts link & EDC '72 C10 "Lowered Farm Truck" STOLEN 5-18-11 '66 impala ht |
|
|
|
|
05-19-2008, 08:22 PM
|
#4 |
|
Registered User
Join Date: Apr 2004
Location: Sacramento
Posts: 3,737
|
Re: pictures of double wall top needed.
Here is a picture I found in LMC. It says they are different, but I would like to make sure I'm ordering the right thing. Therefore, I need a picture of a double wall window opening.
__________________
'72 2wd blazer, bagged w/ watts link & EDC '72 C10 "Lowered Farm Truck" STOLEN 5-18-11 '66 impala ht |
|
|
|
|
05-20-2008, 02:25 AM
|
#5 |
|
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,475
|
Re: pictures of double wall top needed.
Just went out and looked at my 1/2 top, there are no seals on it. Did they glue on to
the openings? (Mine looks like no seals are used, but I haven't mounted it to confirm)
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Big Piggy: "Goliath" 07 Kodiak C4500 Lil Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
|
|
|
05-20-2008, 02:27 AM
|
#6 |
|
Registered User
Join Date: May 2008
Location: AuGres, Mi
Posts: 82
|
Re: pictures of double wall top needed.
Are these what your looking for?? The PO put some funky silicone to seal better, hopefully that's what you wanted to see.
|
|
|
|
|
05-20-2008, 05:49 AM
|
#7 |
|
Registered User
Join Date: Apr 2004
Location: Sacramento
Posts: 3,737
|
Re: pictures of double wall top needed.
Yes, thanks for the pictures. I was hoping to see where the rubber ends, so if you have any more, post away. Thanks again. Oh, and Welcome to the board. Nice blazer.
__________________
'72 2wd blazer, bagged w/ watts link & EDC '72 C10 "Lowered Farm Truck" STOLEN 5-18-11 '66 impala ht Last edited by hotrodhomi; 05-20-2008 at 05:50 AM. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
