Need some odds and ends? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Thealien** · 05-21-2008, 07:38 PM

I need the screws that go into the vent window on 1972 doors and the scews that go in the cowl by the windshield wipers.

Anybody have these laying around?

Thanks
Mark

JimKshortstep4x4 · 05-22-2008, 02:33 AM

I use stainless screws in these locations and they are available from the local hardware. They don't rust!

Jim

**Thealien** · 05-22-2008, 03:02 PM

Quote:

Originally Posted by JimKshortstep4x4

I use stainless screws in these locations and they are available from the local hardware. They don't rust!

Jim

I tried that on the door, the head is too small? I wanted the correct screws to make sure they work and then I was going to try to replace with stainless.

05-21-2008, 07:38 PM	#1
Thealien Senior Member Join Date: Jun 2007 Location: Pine Ridge Florida Posts: 4,134	Need some odds and ends? I need the screws that go into the vent window on 1972 doors and the scews that go in the cowl by the windshield wipers. Anybody have these laying around? Thanks Mark

05-22-2008, 02:33 AM	#2
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Re: Need some odds and ends? I use stainless screws in these locations and they are available from the local hardware. They don't rust! Jim __________________ 1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.