|
06-06-2008, 06:29 AM
|
#1 |
|
Registered User
Join Date: Feb 2008
Location: Redding Ca
Posts: 39
|
fender question
Hi, Im new to this board and would like to know how to adjust my fenders on my 70 chevy,The gap between hood and fenders is 1/2 inch at the front and tappers down to 1/4 inch at the cowl,(both sides) I took lose the bolts from the radiator support but the fenders wont move in,Which bolts do i need to remove?? Thanks Mark.
|
|
|
|
06-09-2008, 08:00 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: fender question
Welcome to the 67-72 Chevy Trucks
site! Loosening the bolts at the triangles and the bolts that bolt the front of the fender to the support should allow you to move the fenders in. The fenders will not move in easily and you may have to elogate some of the holes to gain 1/2" as that is a lot. Loosening the two rear fender to cab bolts may also help you in moving the fronts of the fenders in. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
06-13-2008, 04:18 AM
|
#3 |
|
member
Join Date: Dec 2003
Location: Silver Spring Md.20901
Posts: 2,031
|
Re: fender question
Welcome to the board from Maryland!!
__________________
1967 C/K10 Chevy Panel 1968 C/K20 Chevy Pickup 1968 C/K10 Chevy Suburban 1941 Chevy Sedan Delivery 1960 Chevy Sedan Delivery 1972 Camaro SS 396 #s matching 1971 Harley FX Superglide |
|
|
|
|
06-14-2008, 12:32 AM
|
#4 |
|
Registered User
Join Date: Feb 2008
Location: Redding Ca
Posts: 39
|
Re: fender question
Thanks guys.....Mark
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
