i need some thought and ideas for my bed please

[pissonNOS]

well ever since i put in the c notches and the blocks under my axles now i have the problem of the rearend hitting the wood floor. Im sure i could just use shorted blocks or adjust the bump stops but i really like the stance my truck has now. What do you guys think of cutting out a small section for the diff to pop thru the few inches it might need? any one else have some ideas?

[pissonNOS]

hes is a very crude interpretation of what i had in my mind, the blue part is where i thought id make a frame just so it doesnt look scabby and you see the cut wood?? P.S. that black blob is supposed to be my diff

[jjk3]

I've seen a few people do it that way. You could also raise the wood floor a few inches so you wouldn't have a hole in it. It all depends on what you like, and how far you are willing to go. Good luck. John

[smoknbarrels]

i plan on fabbing a sheet metal piece to go from wheel well the wheel well.. but then again my wells will be closer because of tubbing, but just a thought of a clean install.?

[abadsvt]

Here is what this person did. Looked nice when i saw it. You could do something slightly smaller also.

Josh

[pissonNOS]

thats what i was thinking but like you said on a smalle sscale