Restored POWER in my 98! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

70c10 · 06-25-2008, 07:18 AM

Yesterday I took the 10 minutes required to pull my MAF sensor and clean it and what a difference it made!

I haven't done this since the fall. I highly recommend doing it! Feels like a big block and will spin my 32" tires with ease

mekdad · 06-25-2008, 01:02 PM

what do you clean it with and is it a s10 4.3?

70c10 · 06-25-2008, 02:03 PM

I used CRC MAF sensor spray from my local parts store and yes mine is the 4.3

http://www.autobarn.net/maairflsecl1.html

mekdad · 06-25-2008, 02:29 PM

Hey thanks,going to try some today.Have you done any mods to your motor?

gchemist · 06-26-2008, 08:00 AM

Yup, MAF are the trick to efficiency. The sensor changes fuel and air ratios to match air flow. Keep it clean!! I clean mine every 6 months or as needed.

70c10 · 06-28-2008, 05:05 PM

mekdad- my motor has been converted to the newer style MFI injector setup which is pretty nice but is otherwise stock with 223,000. I put on a new cat and Hooker Aerochamber muffler. I can honestly say the muffler performance was felt immediately

ghemist- I agree every 6 months is a good idea. I also changed the air filter and picked up at least 1 MPG

Not bad for 10-15 minutes of work!

I filled up yesterday and will test it for sure this week

gchemist · 06-28-2008, 09:06 PM

I'm replacing the muffler on my Jimmy this summer. I'm not sure what to put on it. The Magna flows on my truck are awsome. Duals are great. However, I want my Jimmy a little quieter. Do have a sound clip of the Aerochamber? I can handle some sound but not too much. Even now the stock muffler sounds nice and throaty at low and part idle.

70c10 · 06-29-2008, 11:47 AM

Since this is my daily driver and I wasn't interested in noise, this is a good choice and a few people have complimented the sound. It's not much louder than stock. The best part is it's high quality and flows alot of cfm that you can really feel

My buddy spliced it right into my existing pipe with a fitting or two and it's about the same dimensions as the stock muffler. I replaced my hollowed out cat with a Summit brand stainless model also. I'll try to get a sound clip this week but I have no clue how to post it.

**bwood** · 06-29-2008, 11:48 PM

Just a note on the dirty MAF sensor. I used to have a few S10s in the family. All but one had the 4.3. Three of the V6 motors had K&N air filters on them. The ran great, but within about 3 to 6 months, they started to throw MAF codes. Come to find out after talking to a service manager at my Chevy Dealer, it was not uncommon to see the K&N oil collected on the screen of the MAF. I did the same thing with the MAF cleaner and it fixed the prob. I also cleaned the filters and reoiled and let the oil sit for about a day before reinstalling.

gchemist · 06-30-2008, 11:23 AM

70C10,
Send me the clip. I can post the sound clip on a hosting site.

70c10 · 06-30-2008, 10:30 PM

Gerardo- I figured it out and posted them in your Muffler thread!

06-25-2008, 07:18 AM	#1
70c10 67-72 Addict! Join Date: Feb 2002 Location: The TAX State! Posts: 7,856	Restored POWER in my 98! Yesterday I took the 10 minutes required to pull my MAF sensor and clean it and what a difference it made! I haven't done this since the fall. I highly recommend doing it! Feels like a big block and will spin my 32" tires with ease __________________ Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads

06-25-2008, 01:02 PM	#2
mekdad Registered User Join Date: May 2008 Location: Filer, Idaho Posts: 416	Re: Restored POWER in my 98! what do you clean it with and is it a s10 4.3? __________________ you never know what you can do until you have to undo something you have done!

06-25-2008, 02:03 PM	#3
70c10 67-72 Addict! Join Date: Feb 2002 Location: The TAX State! Posts: 7,856	Re: Restored POWER in my 98! I used CRC MAF sensor spray from my local parts store and yes mine is the 4.3 http://www.autobarn.net/maairflsecl1.html __________________ Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads

06-25-2008, 02:29 PM	#4
mekdad Registered User Join Date: May 2008 Location: Filer, Idaho Posts: 416	Re: Restored POWER in my 98! Hey thanks,going to try some today.Have you done any mods to your motor? __________________ you never know what you can do until you have to undo something you have done! Last edited by mekdad; 06-25-2008 at 02:30 PM.

06-26-2008, 08:00 AM	#5
gchemist BAD BOW-Silverado XST Join Date: May 2000 Location: Senior Member from Austin, TX Posts: 6,431	Re: Restored POWER in my 98! Yup, MAF are the trick to efficiency. The sensor changes fuel and air ratios to match air flow. Keep it clean!! I clean mine every 6 months or as needed.

06-28-2008, 05:05 PM	#6
70c10 67-72 Addict! Join Date: Feb 2002 Location: The TAX State! Posts: 7,856	Re: Restored POWER in my 98! mekdad- my motor has been converted to the newer style MFI injector setup which is pretty nice but is otherwise stock with 223,000. I put on a new cat and Hooker Aerochamber muffler. I can honestly say the muffler performance was felt immediately ghemist- I agree every 6 months is a good idea. I also changed the air filter and picked up at least 1 MPG Not bad for 10-15 minutes of work! I filled up yesterday and will test it for sure this week __________________ Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads

06-28-2008, 09:06 PM	#7
gchemist BAD BOW-Silverado XST Join Date: May 2000 Location: Senior Member from Austin, TX Posts: 6,431	Re: Restored POWER in my 98! I'm replacing the muffler on my Jimmy this summer. I'm not sure what to put on it. The Magna flows on my truck are awsome. Duals are great. However, I want my Jimmy a little quieter. Do have a sound clip of the Aerochamber? I can handle some sound but not too much. Even now the stock muffler sounds nice and throaty at low and part idle.

06-29-2008, 11:47 AM	#8
70c10 67-72 Addict! Join Date: Feb 2002 Location: The TAX State! Posts: 7,856	Re: Restored POWER in my 98! Since this is my daily driver and I wasn't interested in noise, this is a good choice and a few people have complimented the sound. It's not much louder than stock. The best part is it's high quality and flows alot of cfm that you can really feel My buddy spliced it right into my existing pipe with a fitting or two and it's about the same dimensions as the stock muffler. I replaced my hollowed out cat with a Summit brand stainless model also. I'll try to get a sound clip this week but I have no clue how to post it. __________________ Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads

06-29-2008, 11:48 PM	#9
bwood Registered User Join Date: Jan 2003 Location: Denison, Texas Posts: 1,919	Re: Restored POWER in my 98! Just a note on the dirty MAF sensor. I used to have a few S10s in the family. All but one had the 4.3. Three of the V6 motors had K&N air filters on them. The ran great, but within about 3 to 6 months, they started to throw MAF codes. Come to find out after talking to a service manager at my Chevy Dealer, it was not uncommon to see the K&N oil collected on the screen of the MAF. I did the same thing with the MAF cleaner and it fixed the prob. I also cleaned the filters and reoiled and let the oil sit for about a day before reinstalling. __________________ 1998 GMC Sierra SLE 1/2 ton 2WD 305 Vortec -Gibson Stainless Cat Back Swept Side -SS Wheels 2005 Honda CRF250R 2006 Honda CRF150F

06-30-2008, 11:23 AM	#10
gchemist BAD BOW-Silverado XST Join Date: May 2000 Location: Senior Member from Austin, TX Posts: 6,431	Re: Restored POWER in my 98! 70C10, Send me the clip. I can post the sound clip on a hosting site.

06-30-2008, 10:30 PM	#11
70c10 67-72 Addict! Join Date: Feb 2002 Location: The TAX State! Posts: 7,856	Re: Restored POWER in my 98! Gerardo- I figured it out and posted them in your Muffler thread! __________________ Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.