to c-notch or not to notch - The 1947 - Present Chevrolet & GMC Truck Message Board Network

avysittinon22s · 07-30-2008, 05:15 PM

got the rear of my 71 bagged, cut 2 pc driveshaft bracket off crossmember. Driveshaft now had 1 1/4" from hitting crossmember, I am gonna have to get a panhard bar to realign rear end. Panhard bar has 1/2" clearence from hitting frame. Should I do a c-notch? All I would gain would be a inch and have to fab a panhard bar and mount. Not sure if an inch is worth all the trouble. All measurements was air bags air out. What you guys think?

umwtnt · 07-30-2008, 05:43 PM

An inch is more then you have now, go for it. It seems everytime we lower one its not low enough so go for the gusto now and get what you can. Good Luck

07-30-2008, 05:15 PM	#1
avysittinon22s Registered User Join Date: Jun 2006 Location: Paris, TN Posts: 376	to c-notch or not to notch got the rear of my 71 bagged, cut 2 pc driveshaft bracket off crossmember. Driveshaft now had 1 1/4" from hitting crossmember, I am gonna have to get a panhard bar to realign rear end. Panhard bar has 1/2" clearence from hitting frame. Should I do a c-notch? All I would gain would be a inch and have to fab a panhard bar and mount. Not sure if an inch is worth all the trouble. All measurements was air bags air out. What you guys think? Last edited by avysittinon22s; 07-30-2008 at 05:15 PM.

07-30-2008, 05:43 PM	#2
umwtnt Registered User Join Date: Feb 2008 Location: Williamsburg, Va Posts: 226	Re: to c-notch or not to notch An inch is more then you have now, go for it. It seems everytime we lower one its not low enough so go for the gusto now and get what you can. Good Luck



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.