|
08-06-2008, 12:11 AM
|
#1 |
|
Registered User
Join Date: Jul 2008
Location: Vancouver BC
Posts: 448
|
rear axle
Hey everyone,
I was just wondering if a 12 bolt 72 chevy c10 5 lug axle would fit in my 65 burb, its a 6 lug i think its a 12 bolt also. |
|
|
|
08-06-2008, 12:39 AM
|
#2 |
|
Registered User
Join Date: Dec 2007
Location: Palmer, Alaska
Posts: 13,821
|
Re: rear axle
should bolt right in
__________________
 CHEVY ONLY
|
|
|
|
|
08-06-2008, 01:48 AM
|
#3 |
|
Registered User
Join Date: Jun 2008
Location: North SD County
Posts: 631
|
Re: rear axle
Only differance may be the pan hard bar/track arm lenth. The mount on the diff housing may be different between 65 vs 72.
I came across this issue when using a 67 C10 rearend on my last 64 C10. Good luck! edit: The understanding is that the 63-64 and 65-72 trackarm are different in length. So you actually may be OK if both rigs are 1/2 tons. Good luck!
__________________
..............................._________ ......___________//___[[___{\ _____ ...../__(_(O)_)___/____/____/_(O)_/ 1964 C20 Long Stepside 3 Door Crew Cab - Armbruster-Stageway Conversion Y2K INDN Chief "ONE OF A KIND, NOT ONE OF THE CROWD" Aug 2010 - Front end frame cleanup & engine swap done!!! June 2011 - Rear end bagged Sept 2011 - Rebuild motor top end Sept 2012 - Parked and slowly working on it. Aug 2013 - Front end bagged - finally! Aug 2014 - Stepside swap conversion done. Finally ready to start bodywork! Have a few KEWL ideas... Here is my build thread: http://www.67-72chevytrucks.com/vboa...d.php?t=335427 Last edited by 64c20crewcab; 08-06-2008 at 04:06 AM. Reason: more info added... |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
