crankcase evac

[71Dragtruck]

Originally Posted by 67dragtruck

Here's a pic of a moroso run with the cog type setup on my small block from the dragtruck. I ran -12 lines, with the fitting welded into the valve cover and the outlet side to one of the moroso cans.

Unfortunately to get a pump, the lines and fittings, the can, the pulleys and drive mandrel, you are talking about spending 800-900. That's tough to take for a 500 HP motor. You can probably find the same power somewhere else for less.

Tom

A bit off topic, but how is or was that manual rack for steering, compared to original power and old style strong arm? Was thinking of going that route when I do a Fat Man front end. Maybe DJ could answer too with the extra BB weight on it.

[67dragtruck]

Originally Posted by 71Dragtruck

A bit off topic, but how is or was that manual rack for steering, compared to original power and old style strong arm? Was thinking of going that route when I do a Fat Man front end. Maybe DJ could answer too with the extra BB weight on it.

When I originally installed it I had a BBC combo in it. It steers great and much better than the factory stuff.

Tom