|
02-17-2003, 03:34 PM
|
#1 |
|
Better late than never
 
Join Date: Dec 2001
Location: Columbus, IN
Posts: 324
|
Motor mounts
I can't remember what bolt is used to attach the mount to the tower. Also, is it just a bolt & washer, or is there another rubber piece that I should be looking as well.
Sure wish I would've been more organized 10 yrs ago when I stripped the truck apart. Thanks for your help.
__________________
1970 C/10 SWB Stepside |
|
|
|
02-17-2003, 03:54 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
If its an I 6 , or a sb it has a 7/16-14 NC bolt approx 1 " long with a lock washer,& a large flatwasher......no other parts on the bottom. crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
02-17-2003, 05:12 PM
|
#3 |
|
Better late than never
Join Date: Dec 2001
Location: Columbus, IN
Posts: 324
|
Thanks crazyl, I appreciate the reply. After a long, 10 yrs, the engine is going in.
__________________
1970 C/10 SWB Stepside |
|
|
|
|
02-17-2003, 05:26 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
I have had my longhorn for 18 yrs, the first 8 or 9 yrs it was pcs......I do understand about a long term project! dont priorities"bite"? good luck with the project....crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
