|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-05-2008, 10:57 AM
|
#1 |
|
Registered User
Join Date: Oct 2006
Location: Hattiesburg, MS
Posts: 137
|
Drop Spindle install question.....
Ok...I have ECE 2.5 Drop member that I am currently installing.......I replaced the lower ball joins while I was doing the Drop member install...Have them pressed in and am now to the point where I put the drop member on the ball joints.....In ECE's they make it sound like you put it on...and it just slides down to the proper position. I put the spindle on and it goes down to about 1/2 inch from the top of the greese bushing....do I need a special tool to get it down? Is it supposed to just go all the way down with no force...or do I just need to crank on the bolt to get it down...or do I have a wrong lower ball joint?
Thanks ahead of time for any help..
__________________
 The stupidty of your actions is directly proportionate to the number of people watching you...
|
|
|
|
10-05-2008, 04:45 PM
|
#2 |
|
Registered User
Join Date: Feb 2007
Location: knoxville tn
Posts: 1,013
|
Re: Drop Spindle install question.....
ok iam lost is this a drop spindle that you are talking about? the older bottem a arms use a smaller ball joint. maybe i helped lol
__________________
nickle and dime |
|
|
|
|
10-05-2008, 05:45 PM
|
#3 |
|
Registered User
Join Date: Oct 2006
Location: Hattiesburg, MS
Posts: 137
|
Re: Drop Spindle install question.....
I figured it out...the boot on this ball joint was different and I didn't think the drop spindle was sitting low enough but it is...thanks for the reply though...
__________________
The stupidty of your actions is directly proportionate to the number of people watching you...
|
|
|
|
|
10-05-2008, 05:59 PM
|
#4 | |
|
Registered User
Join Date: Feb 2007
Location: knoxville tn
Posts: 1,013
|
Re: Drop Spindle install question.....
Quote:
__________________
nickle and dime |
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
