Keep it or trade it for a new one. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Stepside65 · 11-09-2008, 02:14 PM

I found a 65 chevy longbed with a 305 V8 and th350. I've been thinking of selling off the shortbed stepside i have. I've grown tired of fighting with this ancient monster over the last year of me owning it, but i've put more hours than i care to count into it already. I'm terrible at wiring so i'm thinking about selling my truck and buying this one. Then at least i have the 65 chevy pickup that i wanted that runs. My time and funds are limited now due to being married with 2 small children. What do you think i should do?

linky to the possible replacement truck.
http://elpaso.en.craigslist.org/cto/911737604.html

wild one · 11-09-2008, 06:22 PM

I say keep what you already have - you know what you have done to it and what it still needs ( could also be an arguement to get rid of it though....

) if all it really needs is wiring find a friend you trust to help with the job. Two heads really are better then one on a full rewire job - kind of acts as a check and balance system. You never know what the "new" truck might actually need - could be worse than what you already have. Just my .02 though.

Good Luck with the tough decision,
Pete

TimE · 11-09-2008, 07:53 PM

I say keep what you have. Chances are that the longbed in the ad has a hacked wiring harness in it. I haven't ran across very many older vehicles of any make that some "wiring guru" hasn't taken a shot at. It also sounds like you'd be doing a brake job soon.

Something that puzzles me about the ad, too, is it says the truck has a Holley Double Pumper. There's a couple scenarios that come to mind on that one.
1-It's a Holley so he thinks its a double pumper
2-If it is a DP then it has been jetted way down or it's going to flood out that little 305 idleing

IMO, if you are determined to replace your current truck, go look at this one with an open mind, closed wallet and take an uninvolved 3rd person with you that will give you their HONEST opinion about it. Then go home and sleep on it before you make up your mind. If you decide this not the one for you, keep looking. Something will turn up!!

Good Luck!!!!

1966gmc · 11-09-2008, 08:03 PM

Im so tired of working on mine as well man but don't let it get the best of you. I have sunk so much time and money into my truck at this point, I could have almost paid off one of my new cars and its still a pile of junk in my eyes. We must forge ahead and complete these beast lol

283 Man · 11-09-2008, 08:09 PM

that possible replacement dont look bad

.

**scotts62** · 11-09-2008, 11:58 PM

I say keep yours it looks to be in better shape from the pics..
Plus yours is a stepside gotta love em

65ShortStep · 11-10-2008, 12:51 AM

I'd say keep the one you have. You know for sure the condition it is in. If you need help wiring send me a PM, I'm not the greatest, but I'm sure between the two of us we can figure it out. Plus it'll give more experience for when I start rewiring my beast.

View Poll Results: Keep it or trade it?
Keep the 65 shortbed and find someone to wire it.	9	69.23%
Sell it and buy 65 longbed that has the running motor.	4	30.77%
why are you wasting my time?!	0	0%
Voters: 13. You may not vote on this poll

11-09-2008, 02:14 PM	#1
Stepside65 Still Truckless! Join Date: Jul 2007 Location: Valrico, Florida Posts: 3,166	Keep it or trade it for a new one. I found a 65 chevy longbed with a 305 V8 and th350. I've been thinking of selling off the shortbed stepside i have. I've grown tired of fighting with this ancient monster over the last year of me owning it, but i've put more hours than i care to count into it already. I'm terrible at wiring so i'm thinking about selling my truck and buying this one. Then at least i have the 65 chevy pickup that i wanted that runs. My time and funds are limited now due to being married with 2 small children. What do you think i should do? linky to the possible replacement truck. http://elpaso.en.craigslist.org/cto/911737604.html __________________ ~James Truckless 2009 Hyundai Sonata<~~Wife's sedanomatic 1997 Nissan Pickup Father-in-law's tonka toy I am forced to drive Founder of The 60-66 Club Tutor Et Ultor Last edited by Stepside65; 11-09-2008 at 02:17 PM.

11-09-2008, 06:22 PM	#2
wild one Registered......... Join Date: May 2006 Location: Livermore,CA Posts: 288	Re: Keep it or trade it for a new one. I say keep what you already have - you know what you have done to it and what it still needs ( could also be an arguement to get rid of it though.... ) if all it really needs is wiring find a friend you trust to help with the job. Two heads really are better then one on a full rewire job - kind of acts as a check and balance system. You never know what the "new" truck might actually need - could be worse than what you already have. Just my .02 though. Good Luck with the tough decision, Pete __________________ 1966 C10 panel-400 small block/TH 350 combo Nothing is fool proof to a talented fool! Popcorn: Pops at exactly 444 degreese Expands to 44 times it's original size Has a 4 year shelf life

11-09-2008, 07:53 PM	#3
TimE Hey Y'all!! Join Date: Dec 2007 Location: Bay Minette, Alabama Posts: 1,755	Re: Keep it or trade it for a new one. I say keep what you have. Chances are that the longbed in the ad has a hacked wiring harness in it. I haven't ran across very many older vehicles of any make that some "wiring guru" hasn't taken a shot at. It also sounds like you'd be doing a brake job soon. Something that puzzles me about the ad, too, is it says the truck has a Holley Double Pumper. There's a couple scenarios that come to mind on that one. 1-It's a Holley so he thinks its a double pumper 2-If it is a DP then it has been jetted way down or it's going to flood out that little 305 idleing IMO, if you are determined to replace your current truck, go look at this one with an open mind, closed wallet and take an uninvolved 3rd person with you that will give you their HONEST opinion about it. Then go home and sleep on it before you make up your mind. If you decide this not the one for you, keep looking. Something will turn up!! Good Luck!!!!

11-09-2008, 08:03 PM	#4
1966gmc Why does it taste purple? Join Date: Sep 2007 Location: Cambridge Md Posts: 621	Re: Keep it or trade it for a new one. Im so tired of working on mine as well man but don't let it get the best of you. I have sunk so much time and money into my truck at this point, I could have almost paid off one of my new cars and its still a pile of junk in my eyes. We must forge ahead and complete these beast lol

11-09-2008, 08:09 PM	#5
283 Man Registered User Join Date: Apr 2007 Location: Jane,Missouri Posts: 844	Re: Keep it or trade it for a new one. that possible replacement dont look bad.

11-09-2008, 11:58 PM	#6
scotts62 One day... Join Date: Apr 2008 Location: Tuttle, Ok Posts: 9,243	Re: Keep it or trade it for a new one. I say keep yours it looks to be in better shape from the pics.. Plus yours is a stepside gotta love em __________________ Scott 93 crew cab build Project 62

11-10-2008, 12:51 AM	#7
65ShortStep Registered User Join Date: Jun 2008 Location: Alamogordo, NM Posts: 57	Re: Keep it or trade it for a new one. I'd say keep the one you have. You know for sure the condition it is in. If you need help wiring send me a PM, I'm not the greatest, but I'm sure between the two of us we can figure it out. Plus it'll give more experience for when I start rewiring my beast. __________________



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.