|
02-24-2003, 01:33 AM
|
#1 |
|
dropped69
Join Date: Jan 2003
Location: Grand Canyon State
Posts: 120
|
Body Question
Ok folks, I'm to the point where I am sanding the truck down, I noticed my rear quarter panels on my bed were a lot more bondod than I thought
 in fact, I looked at it last night and noticed that the crease that runs all the way down the truck in the body is kind of flat on my right rear quarter panel. Should I just buy a new panel, or how can I use my bondo to get the crease even with the rest of the truck. I wish I could show a picture, but I can't. If anyone knows what i'm talking about, please help me I really need to get my truck going again. Thanks. |
|
|
|
02-24-2003, 02:55 AM
|
#2 |
|
Registered User
Join Date: Aug 2001
Location: escondido, ca 92026
Posts: 1,222
|
you can re-create the body line with bondo and some time and patience, depends on how much needs to be re-done... a long board air sander would really come in handy for this...
__________________
'72 short step, 350, 700R4, tilt, ps, pdb, a/c, lowered coils, etc., other work in progress... San Diego, CA 72 Stepside Project |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
