|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
01-08-2009, 09:11 PM
|
#1 |
|
Registered User
Join Date: Dec 2008
Location: west monroe, louisiana
Posts: 14
|
Re: "Don’t tighten it any more - it’s going to crack"!
Dont feel bad. I've done this myself. Haven't since though. Think about this when you put in another tranny and this wont happen
|
|
|
|
01-09-2009, 05:07 PM
|
#2 |
|
283 Drama Queen
 
Join Date: Dec 2004
Location: Surf City, CA
Posts: 2,435
|
Re: "Don’t tighten it any more - it’s going to crack"!
 Okay kids, the TH350 is at the transmission shop.Shop dude says they're going to pull the pump anyway - so it should be good when he finishes. The welder guy left the inside of the bell housing covered in aluminum dust cause his compressor died, but shop dude says don't sweat it. The welding is perfect - with nice beads, inside and out and he also reamed out the thrust pin hole. Now we'll shoot for square one again - in a couple of days. Mac. 
__________________
For about 12 years of my adult life I had a severe speech impediment. My ex-wife never let me get a word in edgewise. Last edited by MacAttack; 01-09-2009 at 05:07 PM. |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
