|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-10-2009, 02:13 PM
|
#1 |
|
Registered User
Join Date: May 2008
Location: san antonio, texas
Posts: 412
|
really quick question?
im gonna put in a new alternator!
it is a one wire alt but im also gonna put a volt meter, but i want to know if i run the volt meter directly to the slalt? |
|
|
|
01-10-2009, 04:08 PM
|
#2 |
|
Active Member
 
Join Date: Jul 2007
Location: Centrally located between Houston, Austin and Waco. BCS area.
Posts: 7,947
|
Re: really quick question?
To check for voltage you put the plus side to the hot wire and the other side to ground. I would think all you need to do is to splice a wire to the alternator wire and then to the voltmeter and the other side of the voltmeter to ground. Maybe someone else that has done it could chime in.
Make sure you have a good ground from battery to the engine and from engine to frame. May even put one in for the radiator support. A lot of the bolts and metal to metal contact may have oxidized over 30+ years. |
|
|
|
|
01-10-2009, 04:47 PM
|
#3 |
|
Gone to greener pastures
Join Date: May 2007
Location: Gateway to the Delta
Posts: 7,354
|
Re: really quick question?
If you're going to install an aftermarket volt meter, all you need to do is tap into a "switched" power supply like the "ACC" point on your fuse box, or any other thing that turns on & off with the key.
Then a good ground to something metal in the cab.
__________________
'69 Chevy 1/2 T LWB Stepper: Daily Beater '72 GMC 3/4 T Fleet: Another Daily Beater '72 Plymouth Gran Coupe: ? "Ah women. They make the highs higher and the lows more frequent." Friedrich Nietzsche "Never kick a fresh turd on a hot day." Harry S. Truman GUN CONTROL: Never having to say, "I missed you." Always fire two warning shots into your attacker's chest area before putting a bullet between his eyes. Paraphrased from Louis Awerbuck |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
