rear motor mounts - The 1947 - Present Chevrolet & GMC Truck Message Board Network

txstbobcat · 01-11-2009, 12:59 PM

HELP!

63 C-10 6cyl 230

do i have to use both pads on the rear motor mount?

it seems if i use both, it sets the rear of the engine very high putting the drive shaft at a steep angle.

jbgroby · 01-11-2009, 01:22 PM

Bobcat,

I think one of the set goes under the cross member inside of it and the hold down bolt goes through both pieces. That you are damping the vibration from the frame. Check with other members. Do you have a shop manual. it will show you clearly.

My '60 is set up the same way with upper and lower trans mounts.

Jake
Lacombe, LA.

txstbobcat · 01-11-2009, 02:54 PM

THAT WAS IT

THANKS!!! you made my day!!

01-11-2009, 12:59 PM	#1
txstbobcat Registered User Join Date: Jan 2009 Location: New Braunfels, Tx Posts: 6	rear motor mounts HELP! 63 C-10 6cyl 230 do i have to use both pads on the rear motor mount? it seems if i use both, it sets the rear of the engine very high putting the drive shaft at a steep angle. Attached Images

01-11-2009, 01:22 PM	#2
jbgroby Registered User Join Date: Nov 2008 Location: Lacombe, LA Posts: 2,772	Re: rear motor mounts Bobcat, I think one of the set goes under the cross member inside of it and the hold down bolt goes through both pieces. That you are damping the vibration from the frame. Check with other members. Do you have a shop manual. it will show you clearly. My '60 is set up the same way with upper and lower trans mounts. Jake Lacombe, LA. __________________ http://s1299.photobucket.com/user/jb...23904108567829

01-11-2009, 02:54 PM	#3
txstbobcat Registered User Join Date: Jan 2009 Location: New Braunfels, Tx Posts: 6	Re: rear motor mounts THAT WAS IT THANKS!!! you made my day!!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.