|
03-14-2009, 10:25 AM
|
#1 |
|
Account Suspended
Join Date: Feb 2004
Posts: 3,051
|
Measurement needed
Can you measure from the back of the cab to the front of the bed please?
I am doing custom mounts on my bed (new bed floor) and need the right spacing before I start welding. Thanks in advance. Last edited by FormerMember; 04-02-2009 at 03:29 PM. |
|
|
|
03-14-2009, 11:00 AM
|
#2 |
|
Active Member
 
Join Date: Jul 2007
Location: Centrally located between Houston, Austin and Waco. BCS area.
Posts: 7,947
|
Re: Measurement needed
On the top rail to the cab I have min adjusted to 7/8". But, I think you're going to find some differences since the bed is adjustable back and forth a small amount -I believe it can move 1/2 inch or so.
|
|
|
|
|
03-14-2009, 02:13 PM
|
#3 |
|
Account Suspended
Join Date: Feb 2004
Posts: 3,051
|
Re: Measurement needed
Can someone give me the measurement from the head panel to the back of the cab?
Last edited by FormerMember; 04-02-2009 at 03:30 PM. |
|
|
|
|
03-14-2009, 03:35 PM
|
#4 | |
|
Registered User
Join Date: Jul 2000
Location: NC
Posts: 987
|
Re: Measurement needed
Quote:
15/16" from the top of the panel to the cab. |
|
|
|
|
|
03-14-2009, 05:03 PM
|
#5 | ||
|
Active Member
Join Date: Jul 2007
Location: Centrally located between Houston, Austin and Waco. BCS area.
Posts: 7,947
|
Re: Measurement needed
Quote:
Quote:
|
||
|
|
|
|
03-14-2009, 05:37 PM
|
#6 | |
|
Account Suspended
Join Date: Feb 2004
Posts: 3,051
|
Re: Measurement needed
Quote:
Last edited by FormerMember; 04-02-2009 at 03:30 PM. |
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
