proportioning valve question for disk conv

[lolife99]

Originally Posted by SS68

one more question, on the bottom of the proportioning valve the line for the front brakes the fitting that goes in there is 1/8 and i can only fit a 1/8" line all the other lines are 1/4" is this the same on yall?

You need to buy a 3/16" male-to-1/4" female adapter to screw into the bottom of the porportioning valve. This will allow you to run a 1/4" line down to the "T" on the backside of the front crossmember.
I got mine at the local ACE Hardware store. They are specialty fittings. (Inverted flare adapters)